416-HP Mercedes-AMG 4-Cylinder Engine
It makes 416 horsepower and 369 lb-ft of torque in top trim, giving it a specific output of 208.9 horsepower per liter. The brand new engine will likely be put within the A45, the CLA45, the GLA45, and the GLB45. Mercedes-AMG has released full technical particulars on its brand-new M139 four-cylinder engine, and its headline specs are pretty insane. LH and RH engines in inventory! Guarantee is 18 months on non-race motors. 200.00 for Reverse Rotation (besides Roller Functions). These are the identical engines that Mercruiser, OMC, Volvo Penta, Crusader, and so on. buy new from GM and Ford. We've 350 & 454 RH Opposite Rotation…Call! This guarantee is expressly in lieu of every other guarantee expressed or implied, together with however not restricted to merchantability or health for a particular purpose, and all different obligations or liabilities on the part of the remanufacturer. By purchasing this engine it is understood that customer accepts and agrees to comply with the terms of this limited warranty.
The engine was equipped with 270 cc fuel injectors and a dual runner intake manifold. The compression ratio is 9.8:1. The K20A4 is the same K20A3 but tuned for USDM 2003-2007 Honda Accord and 2002-2006 Honda CR-V. The K20A6 is one other version of the K20A3 that was produced for the European and Australian 2003-2006 Honda Accord. In 2007, the K20A engine was revised and upgraded. The bottom obtained new strengthened connecting rods, the compression ratio rose to 11.7:1. It obtained a brand new exhaust manifold, a short RRC intake manifold, and a 64 mm throttle physique. The cylinder head intake and exhaust ports have been reshaped and optimized. Deutz Engine engines power machines which can be, at current, accountable for top ranges of carbon emissions. There's potential for enchancment, which the company aims to unlock because it creates a carbon-impartial product portfolio. 160 years of engine development experience into its Green segment, primarily based on an approach that's fundamentally know-how-impartial.
This is generally the most effective strategy to lighten a crankshaft until you get into expensive counterweight machining. Drilling the crank pins removes weight at the farthest doable level from the center of the crank, thus lowering the rotating inertia. Pressurized oil is delivered to the main bearings through the main oil galleries in the cylinder block.